Similar observations are also seen in the rest of the SAR302503 datasheet as-deposited samples (deposition temperatures from 150°C to 350°C). At the frequency of 1 MHz,

the capacitance is 300 pF in strong accumulation. Enhanced capacitance (1,420 pF) in strong accumulation at a frequency of 100 Hz is observed, which is more than four times the capacitance measured at 1 MHz. Moreover, it is found that the value of accumulation capacitance is inversely proportional to the frequency. The C-V measurements of the annealed samples (solid lines) are also shown in Figure 4. In contrast to the as-deposited high-k thin films, the annealed samples show a pronounced accumulation capacitance reduction, which is mainly due to the increased interfacial layer (IL).

One kind of high-k Natural Product Library research buy materials were researched by our group before: Selleckchem Veliparib La-doped ZrO2 films, with a thickness of 35 nm deposited on n-type Si(100) substrates by liquid injection ALD at 300°C [14]. The 35-nm-thick La0.35Zr0.65O2 layers retained their thickness after PDA, but the IL (SiO x ) increased from 1.5 nm on the as-deposited samples to 4.5 nm after PDA at 900°C in N2, respectively, which is attributed to either an internal or external oxidation mechanism. As high-k layer is on the top of the IL, the capacitance of high-k layer is in series of the IL capacitance. When the thickness of the IL is increased, the capacitance of the IL is decreased, and it is no longer much larger than the high-k layer capacitance. Therefore, the total capacitance (including

the capacitance of the high-k layer and the IL capacitance) is decreased significantly. Generally speaking, the most obvious effect of annealing is therefore to weaken the accumulation capacitance and hence reduce the k-value. Insignificant frequency dispersion is observed from 100 Hz to 1 MHz. The annealed capacitance of 100 Hz decreases by approximately 70% of the as-deposited Clomifene sample. The accumulation capacitance value is 410 pF below 100 Hz. The capacitances from 1 kHz to 1 MHz are in the range of 180 to 240 pF. In order to further investigate the frequency dispersion for CeO2, a normalized dielectric constant (to the dielectric constant at 100 Hz) is utilized to quantitatively characterize the dielectric constant variation. At the start, both as-deposited and annealed samples are used. Concerning the 250°C samples, the comparison between the as-deposited and annealed is given in Figure 5. It is observed that the dielectric relaxation for the as-deposited sample (triangle symbol) is much pronounced than that of the annealed one (square symbol). Within the range of various frequencies, the normalized k value of the as-deposited sample is lower. Obviously, the worst-case situation occurs at 1 MHz when the normalized dielectric constant is 0.11.